TEKVisions 5-Wire Resistive Driver Installation

If installing driver from the TEKVisions website: http://tekvisions.com/drivers_t5r.htm

Pick the correct operating system

Click the filename to download the driver

Select open (or save the file to your hard drive)

In the zip file double click on the SetupCompact.exe

If installing from the Driver CD

Insert the TEKVisions 5-Wire USB Resistive Touchscreen driver CD

Click Start

Click the Install button that matches your operating system

1. Click Next

2. Click Yes.

3. Click Next.

4. Click Next.

5. Click Finish.

6. At this point the driver will be installed and the Main Console screen will open.

7. A message saying Digital Signature Not Found may popup, Click yes to continue.

8. Close the Main Console and reboot the PC.

9. Make sure the USB cable is plugged in.

10. After reboot double click the Main Console Icon on the desktop.

11. Click the Create button.

12. The driver will search for the USB touchscreen controller.

13. Click yes.

14. Under “Operating Mode” (or “Operate Mode”) choose Icon.

15. Under “Double Click” disable Double Click.

16. Under “Calibration” choose 4, 9, 16, 25 or 25 plus. Usually a 4-point calibration will be sufficient.

17. Touch each target until the system beeps or 4 seconds if there are no speakers installed.

18. Under “Utility Tools” click Drawing to test the touch calibration, hit esc to exit.

19. Click apply.

20. Click ok.

The TEKVisions 5-Wire USB Resistive Device Driver has three operation modes.

Direct Mode: While touching the screen, the driver acts as if the Mouse Button is held down. When you move around the sensor, the Mouse Cursor also moves with Button down. When you release your finger from screen the Mouse Button is released.

Icon Mode: Mostly is the same as Direct Mode, but the Cursor will stick on the pressure point for the time span of Double Click Speed settings if your movements has not exceed the space tolerance of Double Click Space settings.  This mode should provide optimum support for both Point of Sale and standard PC use.  This is the default setting on all TEKVisions all-in-one systems.

Window Mode: When you press the Touch screen and move your finger, the Cursor will also move with your finger, but the Mouse Button is not pressed immediately. When you slow down your movements and stop at a point for one or two seconds the Mouse Button will press and the Cursor will move with the Mouse Button Down at the following movements. If you release your finger from the Touch Panel before the Mouse Button has been down, you make a mouse click at the place you release your finger; if you release your finger after the Mouse Button has been down then you make a mouse click at the place you released your finger.

Double Click:  When double touching in the same spot the second touch will act as an auto double click.  While this feature makes opening files and programs easier in an Operating system environment it will cause the system to triple click. It is recommended you disable this feature for any Point of Sale application. This is the default setting on all TEKVisions all-in-one systems.                                                                                

Note: When you switch operation modes, you must press Apply button to save your changes in controller.